- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey,
I'm using CYBLE-416045-02 ble. For testing purpose I'm sending a 2 byte response into to a only read Response characteristic.
I'm able to get data from the ble app but cant send the 2 byte response.Please help.
Thankyou
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Could you please refer to the below attached sample project. In this project, if you write two bytes of data from the central device then the values will be updated into the GATT DB at peripheral device. And, the updated values will be displayed in Central device through read response.
Please let me know if this helps.
Thanks,
P Yugandhar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Could you please refer to the below attached sample project. In this project, if you write two bytes of data from the central device then the values will be updated into the GATT DB at peripheral device. And, the updated values will be displayed in Central device through read response.
Please let me know if this helps.
Thanks,
P Yugandhar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thanks for replying. The project you have shared with me has errors as you can see in below attached image.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I'm able to open the project at my end. Could you please try downloading again ?
Thanks,
P Yugandhar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thanks, your project work fine. But i still have some questions:-
1) I have 2 characteristics named command (write only) and response (read only).
2) I'm able to communicate between psoc6 and mobile app only when i make response characteristic(which should be read only) both read and write.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Continued...
Why am I not able to communicate both ways (app and psoc6) when i configure response characteristics as read only?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks my problem has been solved.It was a typo error, I was using CY_BLE_SMARTDOOR_READ_PACKET_CHAR_INDEX instead of CY_BLE_SMARTDOOR_READ_PACKET_CHAR_HANDLE.
Again thanks for the help.