Dec 26, 2019
09:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 26, 2019
09:36 PM
Hi CY Friend,
My customer has build a pcb of type c to dp dongle, but the aux and sbu has no signal. HPD line is 3.3V.
Can you give some suggestions on what we can do?
Thanks
sophie
Solved! Go to Solution.
Labels
1 Solution
Dec 26, 2019
10:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 26, 2019
10:19 PM
Hi Sophie,
Is this observed even when connected to a Type-C notebook that supports DP and DP configure command is ACK'ed by dongle?
AUX lines are isolated using internal mux by default and connected only on DP configure success.
Regards,
Muthu
1 Reply
Dec 26, 2019
10:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 26, 2019
10:19 PM
Hi Sophie,
Is this observed even when connected to a Type-C notebook that supports DP and DP configure command is ACK'ed by dongle?
AUX lines are isolated using internal mux by default and connected only on DP configure success.
Regards,
Muthu