- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi! Im using capsense and when I try to use sense tuner by I2C, I have a connecting problem.
The error massage says " There was an error reading data from the device" .
If you know any clue, Please let me know.
The detail is below
PSoC: CY8C4147AZI-S475
KITPROG2: CY8C5868LTI-LP039
Digital source power: 3.3V
I2C Speed: 100kHz
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please try with I2C speed as 400KHz and sub-address size as 16 bits/2 Bytes in the Tuner connection set-up GUI.
Please check if I2C lines are connected properly. There should be 330 ohms in series with I2C lines and 4.7 kilo ohms(in general) pull-up resistances to I2C lines.
Check if the I2C pins are selected accordingly in PSoC Creator project. Check if baud rate matches with component and tuner.
Please ensure that power supply is selected as external and connect the VDD and ground lines of the board to Miniprog.
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please try with I2C speed as 400KHz and sub-address size as 16 bits/2 Bytes in the Tuner connection set-up GUI.
Please check if I2C lines are connected properly. There should be 330 ohms in series with I2C lines and 4.7 kilo ohms(in general) pull-up resistances to I2C lines.
Check if the I2C pins are selected accordingly in PSoC Creator project. Check if baud rate matches with component and tuner.
Please ensure that power supply is selected as external and connect the VDD and ground lines of the board to Miniprog.
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you so much!!
Unfortunatly, I cant make it still.
Im using CY8CKIT-149 and I separated KitProg2 board from PSoC 4100S Plus board.
I connected them correctly.
I can write the program but just cant connect by Launch tuner.
Thank you for helping me.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I solved the problem.
I could connect by using J6 pin.
Thank you so much for helping!!