- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a simple question about debugging: I just want to amke sure I buy the right probe so which one should I look for?
Searching for 'CY7C65215' I am suggested by google for the CX3 eval board. What I should do? Buy the eval board? Which probe (vendor and part number please) should I go for? Or should I gat a Segger J-Link? I am lloking for a comfortable and cheap piece of harware which bridges from USB to CX3 JTAG ...
please shade some light
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The reason for asking about the RDK is that, if you had Denebola RDK, then J-link Segger is the apt one since it has a connector for the same.
Since it is a custom board, you can go for
i) CY7C65215 (link for the kit is https://www.cypress.com/documentation/development-kitsboards/cyusbs236-usb-serial-dual-channel-devel...)
Note that for JTAG to work on CY7C65215, UART and JTAG interfaces be simultaneously enabled.
OR
ii) J-Link Segger can also be used.
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you please let us know which CX3 Eval board are you using?
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Does it matters?the cx3 exoposes the jtag I/f straight to the connector. It
is aciustom board btw
Thanks
Il gio 12 dic 2019, 14:28 HemanthR_06 <community-manager@cypress.com> ha
scritto:
<http://www.cypress.com>
Cypress Developer Community
<https://community.cypress.com/?et=watches.email.thread>
CX3 jtag debug
reply from HemanthR_06
<https://community.cypress.com/people/HemanthR_06?et=watches.email.thread>
in USB Superspeed Peripherals - View the full discussion
<https://community.cypress.com/message/218342?et=watches.email.thread#218342>
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The reason for asking about the RDK is that, if you had Denebola RDK, then J-link Segger is the apt one since it has a connector for the same.
Since it is a custom board, you can go for
i) CY7C65215 (link for the kit is https://www.cypress.com/documentation/development-kitsboards/cyusbs236-usb-serial-dual-channel-devel...)
Note that for JTAG to work on CY7C65215, UART and JTAG interfaces be simultaneously enabled.
OR
ii) J-Link Segger can also be used.
Regards,
Hemanth