Welcome to the Infineon Developer Community

Hi 

I want to know  sleep current of TLE9853QX & also it auto wake when LIN signal is available. My customer is using in Flush door handle.

I have seen multiple sleep mode specs available in datasheet  but not able to understand actual avg sleep mode current required.

Regards

Lucky Kumar

TL9183Q MLCC Chip Capacitor for Charge Pump CB 4.7uF It is prone to whistling, and replacing it with a larger or smaller capacitor value does not improve it much.

Any good solutions?

Hello all,

     I am very tired to work with FOC using imc101t-f048, In this FOC method i cannot achieve 3000rpm in 2sec(This is already discussed in this thread  (https://community.infineon.com/t5/Motor-Control-ICs/FOC-vs-Trapesoidal/m-p/711550#M3771)) , so i decided to work in Trapezoidal commutation. Kindly clarify IMC101t-f048 microcontroller does support trapezoidal commutation. If support which software is used for trapezoidal like MCE wizard for FOC? 

Hello everyone, my board needs to use a SmartPIM1 series IGBT module: FP35R12U1T4, according to the SmartPIM1 assembly instructions AN2009_09, PCB boards have a layer of tin after the metalization of the aperture, I would like to ask this layer of tin is plated with the surface treatment using the sinking tin process? It seems that most PCB manufacturers nowadays are spraying tin, and there seems to be only copper on the inside of the holes, will this affect the assembly?

Another problem is that according to the assembly instructions the board needs to be drilled between 1.12mm ~ 1.15mm, I can find the best precision factory crimp hole hole diameter tolerance is also ± 0.05mm, it seems not quite able to meet the error requirements. I would like to ask you to play this kind of board to find what manufacturers to meet the requirements?

Does TC397 support Network 1588 time synchronization protocol? What are the solutions for TC397 time synchronization?

hi，大家好

目前在使用Psoc6 ble开发板开发，M0核和M4核都有使用，分别建立了工程，在各自的核擦写都是成功的。现在遇到的问题是用M0核做boot loader，跳转到M4核执行App后，擦写就会失败 。请帮忙看看，谢谢谢谢！

Hii,

I'm using CYTVII-C-2D-6M-327-SET evaluation kit for my project.   I require information's about pinout details exposed out in dev kit and its schematic diagram .

I couldn't get those documents.  could you support on this ?

Thanks.

Hello,

I am trying to understand the working of various peripherals for the TC397 board. I came across the IfxPort_reg.h file for GPIOs and noticed that there are some missing nos. in the port modules for example after MODULE_P00, MODULE_P01, and MODULE_P02, there is no MODULE_P03. It skips directly to MODULE_P10. More examples can be seen in the screenshot below. I am not sure if this is common knowledge, but is there any particular reason the port modules are named in such a way?

Thanks