- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I am using the CYW920719Q40EVB-01 evaluation kit
I already finish the following items.
1. Create a new project in WICED with just one file which is empty:
#include "sparcommon.h"
APPLICATION_START() {}
2. Download this project from WICED onto your board.
I could sending commands with CyBluetool, and received the correct event.
11/28/19 18:09:19.115 com8 <c Reset
HCI Command Complete Event
com8@115200
[0E 04 ]: 01 03 0C 00
event = 0x0E (14,"Command Complete")
Num_HCI_Command_Packets = 0x1 (1)
Command_Opcode = 0xC03 (3075, "Reset")
Status = 0x0 (0, "Success", "Success")
But if i use other UART console AP, sending the command "01 03 0c 00"
Why i can't receive any feedback by UART console AP?
Have any other setting or initial command to do?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi JaLe_4525111
UART console AP -> Can you please provide information about your host and how you are actually trying to communicate with the device?.
Can you try following workarounds:
1- Do hard reset and then connect the HCI port. After that send HCI reset.
2. Do Recovery and try sending the HCI command.
Recover steps: Reset the board while you are pressing the Recover button and then release the recover button.
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi JaLe_4525111
UART console AP -> Can you please provide information about your host and how you are actually trying to communicate with the device?.
Can you try following workarounds:
1- Do hard reset and then connect the HCI port. After that send HCI reset.
2. Do Recovery and try sending the HCI command.
Recover steps: Reset the board while you are pressing the Recover button and then release the recover button.
Thanks,
-Dheeraj