- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi:
I download the mesh_provision_client firmware to my CYW920735Q60EVB-01 board , and use mesh client control to create a network and a bt mesh device has been
added into the created network. so the added device can be controled by the mesh client control. for example on/off control, now I want to create a scene for the device using the mesh client control. but store a scene for the device, and change the light's on/off status, when I recall the scene I have created. the mesh client control print some messages:
store scene:1
scene recall : 1
scene from: 2 appkey: 1 elements: 206 status:11 current: 56576 target: 65343 remaining time: 33578751
however the light's status have no effects, the scene stores the light's on status, when I recall the scene, the light has not been turned on!
vice versa!
thanks!
mandy
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi DheerajP_41:
I have found the reason why it can't work fine. I use the incorrect app_ key _index for the scene server model.
thanks !
mandy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Are you using the WICED SDK and which demo are you using? The message should be transfer, but the LED control of gpio control may not be added in the application.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi OwenZ_26:
I use the version of WICED SDK is wiced-studio-6.4.0.61 and the hardware platform is CYW920735Q60EVB-01. the gpio of led have been configured, and I can control the led by the mesh client control !
thanks!
mandy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi mawu_4270096
Sorry, I couldn't reproduce the issue at my side.
I tried to store and recall the scenes using mesh_provision_client and light_dimmable application on 20735 platform (in WICED 6.4.0.61). It worked for me.
Few suggestions:
- Use clientcontrol and mesh application from same version of WICED SDK (6.4.0.61)
- Try to create a new network and try.
- Use correct dst addr (it can be 0002 if light_dimmable is the first provisioned node by the mesh_provision_client) and app_key_index (please check the networkname.json file of clientcontrol and use setup key) in the model tab of clientcontrol.
- provide a valid scene number and store it and while recalling please use the same scene number.
Pleas check your configurations and steps once again and let me know if it works.
Otherwise please share the device traces (enable model traces on both the devices) and clientcontrol screenshot/logs.
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi DheerajP_41:
I have found the reason why it can't work fine. I use the incorrect app_ key _index for the scene server model.
thanks !
mandy