- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
The customer is thinking that reading the HX3 firmware written in the external EEPROM. I think that it is possible to read setting value of the configuration by using Bluster Plus. But I want to know the method to read the firmware not bluster setting value but full HX3 firmware from external EEPROM.
Best Regards
Arai
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for the clarification.
As I was mentioning on the previous post, there is no way to do it using HX3 Blaster Plus.
They should get a Firmware (bin file) from the outsourcing contractor. Otherwise, if they can meet their requirements on the firmware by changing only the configuration settings, they can use our firmware (https://www.cypress.com/documentation/software-and-drivers/hx3-firmware ) with changing configuration settings by Bluster Plus.
Regards,
Hirotaka Takayama
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Blaster Plus does not have its functionality.
It is unclear for me why do they want to read the entire HX3 firmware?
Regards,
Hirotaka Takayama
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Takayama san
The customer programs and uses HX3 FW in EEPROM. The programming itself is outsourced to an outside contractor.
This time, there was a problem that the USB device could not be recognized, so they are thinking that there is a problem in the EEPROM itself when the cause was investigated by the customer. Therefore, they are looking for a way to easily read the entire FW written EEPROM. So, It will be investigated whether there is a method that can be read by Cypress tools, or not.
Best Regards,
Arai
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for the clarification.
As I was mentioning on the previous post, there is no way to do it using HX3 Blaster Plus.
They should get a Firmware (bin file) from the outsourcing contractor. Otherwise, if they can meet their requirements on the firmware by changing only the configuration settings, they can use our firmware (https://www.cypress.com/documentation/software-and-drivers/hx3-firmware ) with changing configuration settings by Bluster Plus.
Regards,
Hirotaka Takayama
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Takayama san
Thank you for your reply.
Best Regards
Arai