DeneBola (CX3) with J-Link for debugging error

[NoAr_1540581]

Hello

DeneBola (CX3) and J-Link are connected and debugged, but debug error occurs.Please refer to the attached(Debug_error.png)  for debugging procedures and error results. Is there anything I can assume about the cause of the error?

Also, I understand that the debug step button cannot be pressed as shown in the attachment( Debug_error2.png)due to an error. But Is there any other possible problem besides this error?

Best Regards

Arai

[GiSa_4520796 · Accepted solution]

Hi,

Regarding attachment Debug_error.png ----->

During debug Configuration ,you should untick the "ALLOCATE CONSOLE FOR SEMIHOSTING AND SWO" under DEBUGGER tab.Once try doing this.

Regards,

Srujana.

[NoAr_1540581]

Hello Srujana san

Thank you for your reply. The Pop-up error is solved., but  the debug step button cannot be pressed.  Also, the following error message occurs.

Is there anything I can assume about the cause of the error?

Best Regards

Arai

[GiSa_4520796]

Hi,

The Debug process what you are doing is correct ,it is not an error.You have to just click on yes and continue your process.

Regards,

Srujana.

[YashwantK_46]

Hello Arai-san,

Please refer to the following .pdf file regarding the J-Link debugging of FX3: "C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK\1.3\doc\firmware\EzUsbSuite_UG.pdf"

Please refer to section 3.1 Debugging using Segger J-Link on the complete steps that need to be followed while using Segger J-Link for debugging.

Regards,
Yashwant

[NoAr_1540581]

Hello

Thank you for your reply.

We have done to resolve this issue.

Best Regards

Arai