- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
DeneBola (CX3) and J-Link are connected and debugged, but debug error occurs.Please refer to the attached(Debug_error.png) for debugging procedures and error results. Is there anything I can assume about the cause of the error?
Also, I understand that the debug step button cannot be pressed as shown in the attachment( Debug_error2.png)due to an error. But Is there any other possible problem besides this error?
Best Regards
Arai
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Regarding attachment Debug_error.png ----->
During debug Configuration ,you should untick the "ALLOCATE CONSOLE FOR SEMIHOSTING AND SWO" under DEBUGGER tab.Once try doing this.
Regards,
Srujana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Regarding attachment Debug_error.png ----->
During debug Configuration ,you should untick the "ALLOCATE CONSOLE FOR SEMIHOSTING AND SWO" under DEBUGGER tab.Once try doing this.
Regards,
Srujana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Srujana san
Thank you for your reply. The Pop-up error is solved., but the debug step button cannot be pressed. Also, the following error message occurs.
Is there anything I can assume about the cause of the error?
Best Regards
Arai
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The Debug process what you are doing is correct ,it is not an error.You have to just click on yes and continue your process.
Regards,
Srujana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Arai-san,
Please refer to the following .pdf file regarding the J-Link debugging of FX3: "C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK\1.3\doc\firmware\EzUsbSuite_UG.pdf"
Please refer to section 3.1 Debugging using Segger J-Link on the complete steps that need to be followed while using Segger J-Link for debugging.
Regards,
Yashwant
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
Thank you for your reply.
We have done to resolve this issue.
Best Regards
Arai