- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have just purchased your development kit FM4-176L-S6E2GM (1)
But it seems it was a mistake on my side as I would like to buy the similar one FME-176L-S6E2CC-ETH (2).
This is because I want to use some code already prepared from a book for DSP applications. And the code is target for the board (2)
The problem is that it seems there is not exactly complete compatibility. When I run the code I have installed from your site my board (1) works ok. But If I run the code from the book for board (2) it seems it does not work properly.
In Keil for example I can not see the debug working properly (step by step).
Could you tell me if there are compatibility issues between the two boards.
I do not want to buy another board.
Thank you for the help.
Alberto Nascimento
Solved! Go to Solution.
- Labels:
-
FM0
-
FM0FM3
-
FM3
-
FM3_MCU
-
ispn:39108:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The two boards are not exactly same. The main controllers have different core frequency, flash/sram space size, number of GPIOs.
You need adjust you code according to the hardware differences.
In addition, is it possible to exchange the boards from you purchase channel?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The two boards are not exactly same. The main controllers have different core frequency, flash/sram space size, number of GPIOs.
You need adjust you code according to the hardware differences.
In addition, is it possible to exchange the boards from you purchase channel?