- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am looking at PSoC6 + CY7C68001 (https://www.cypress.com/file/124346/download), which I found as the only possible solution from cypress in combination with PSoC, or would you suggest something else?
The goal is to find an ARM + some programmable logic + high-speed usb.
Best regards,
Uros
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to Cypress FX2LP, a low power High Speed USB peripheral controller which can act as a master (in GPIF mode) and Slave (in Slave FIFO mode) to the device connected, whereas, SX2 acts only can act as a slave to external master.
Best Regards,
Yatheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to Cypress FX2LP, a low power High Speed USB peripheral controller which can act as a master (in GPIF mode) and Slave (in Slave FIFO mode) to the device connected, whereas, SX2 acts only can act as a slave to external master.
Best Regards,
Yatheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you Yatheesh,
not bad, however neither my first proposed neither FX2 have the SOF output pin which could be used in clock sync.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
You can use the IFCLK from the FX2LP device or from the master controller to synchronize the data transfer. SOF interrupts can be used to monitor the start of frame from the USB side to FX2 (slave FIFO mode) and indicate the same to the master side using GPIO.
Please refer to the EZ-USB Technical Reference Manual for detailed description of all the registers and the FX2 device operations in different modes.
Best Regards,
Yatheesh