Capsense Proximity Loop Wire

[jfo_2825136]

Hello,

I have a question about implementing a proximity sensor using a loop wire attached to a GPIO pin on the PSoC CYBLE-416045-02. I have set up a CapSense block and configured it as a proximity sensor then built the project and wrote the attached code. It is set up so that an LED turns off when the proximity widget is active. Having trouble getting the code to work. Any ideas on what is going wrong? Thanks!

[ShipingW_81 · Accepted solution]

We have a capsense proximity demo using PSoC 6. It's attached here for your reference(just ignore the BLE part).