- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In the PSoC4 SCB manual I find a particular statment
Would this mean that 2 communication modes can be enabled simultaneously on a single SCB?
I mean is it possible to enable I2C and SPI on a single SCB block? If so, how would the pins be configured for the same?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
1) Yes at particular time only one mode can be active.
2)" I mean If I want to use I2C and SPI on a single SCB, I would have to first configure as I2C use it then stop it and then configure the SCB as SPI use it etc" - YES.
3) "Is it possible to use the SCB with 2 modes at the same time, simultaneous?" - NO
Regards
Alakananda
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes,one SCB can be configured two different interface, by it needs to be configured in different time.
You can open the SCB datasheet, can refer to it from page 4, 7,8,9.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
By different time, do you mean at any time only one mode can be active?
I mean If I want to use I2C and SPI on a single SCB, I would have to first configure as I2C use it then stop it and then configure the SCB as SPI use it etc.
Is it possible to use the SCB with 2 modes at the same time, simultaneous?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
1) Yes at particular time only one mode can be active.
2)" I mean If I want to use I2C and SPI on a single SCB, I would have to first configure as I2C use it then stop it and then configure the SCB as SPI use it etc" - YES.
3) "Is it possible to use the SCB with 2 modes at the same time, simultaneous?" - NO
Regards
Alakananda