- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am designing a prototype board with PSoC 4 WLCSP package device (CY8C4014FNI-421AT). I went through the sample schematics for CY8CKIT-040 and also checked the Technical Reference manual for the device family, but I am not sure on how to terminate unused GPIO pins such as the Trigger Input pin (In my case P 0.2).
For now, I have simply left the unused GPIO pins suspended, but I am not sure about these Trigger input pins that can also be used as CDS sense or as shield pins that are connected to AMUXBUS A or B.
It will be great if someone could advise me regarding this concern.
Thanks and Regards,
Nandhini Jayapandian
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I think that the following topic is a good reference.
unused pin configured internal pull up pull down
Not directly related, may be a good information
moto
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I think that the following topic is a good reference.
unused pin configured internal pull up pull down
Not directly related, may be a good information
moto