CYBLE-022001 EMC test with constant TX/RX

[ThJu_878946]

for EMC test I need to put the BLE radio of the BYBLE-022001 in a particular test mode, i.e. contiguous transmit on a low/mid/high frequency channel at low/mid/high power and in contiguous receive mode. My PCB allows access to the serial interface via FTDI USB-UART. Is there any example program which allows me to switch between such modes, e.g. HCI or AT commands etc.

[Yugandhar · Accepted solution]

Hello,

Please find the firmware attached with the below KBA for the RF certification.

Test Firmware for PSoC®/PRoC™ BLE RF Certification – KBA220073

Thanks,

P Yugandhar.