- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
How do I change the Vref on the SAR ADC during run time? I'm using single ended configuration with VSS at negative Vinput.
thank you
Shawn
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Shawn,
This can be done. Please check the following KBA. Also make sure that you are giving enough delay between changing Vref to get accurate results.
Dynamically Changing Vref in SAR ADC – KBA227544
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Shawn,
This can be done. Please check the following KBA. Also make sure that you are giving enough delay between changing Vref to get accurate results.
Dynamically Changing Vref in SAR ADC – KBA227544
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you
This was the solution.
Where can I find a list of the registers within the PSOC 4200?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Shawn,
Device Registers TRM has this information will have all the information about the registers. See PSoC 4200 Registers TRM for more details.
Best Regards.
Vasanth