- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I create schematic from the reference design CCG3PA 45W car charger with SC8815, i would like to know where can i find the code exemple for it (not the firmware). Cause i have minor modifications.
And the CYPD3171-24LQXQ_cla code exemple is nkt the same at all with this car charger reference design.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry about that. Here is the unprotected zip package attached.
Regards,
Rajath
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
The CCG3PA 45W Car charger reference design source code is not public. Thank you for your understanding.
Regards,
Rajath
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What should i change on CYPD371-24LQXQ_cka to make it works with the CCG3PA 45w cra charger référence design thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No Rajath,
we do not understand.
I'm struggling for weeks now to get a reference design working (ccg3pa 39W), without success.
What is the point of reference designs? To help customers fast and accurate!
We are in an evaluation process; I can guarantee you that this is not the way to convince possible customers.
Very bad marketing. I can assure you that many other manufacturers do it the right way.
What are actually the fears by exposing some example code?
Lisa is doing a good job trying to help me; but it is difficult without decent example code.
Regards,
Wim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello thanks for your reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey thanks for the support but the zip need code to unzip how can we get it ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks so much for the share this really help us a lot a accelerate our design,
Just one quest is it normal that the INT pin is not on the schematic design ?
And is it possible also to have PB811 project source ?