- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
I know that pull- up or pull-down resistor is used to prevent the digital input from floating. I would like to ask you if I need to add pull down or pull up resistor on my circuit.
The API code is generated for Microcontroller to return 0 or 1 value to control the demultiplexer. Demux is active low. So, If MCU return the low(0) value then, demux will perform its job. The high (1) signal from MCI would set the demux off.
state
Idle : High
the moment of need : Low
return to high
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
If you need the demux to inactive by default, use a pull up network. When the demux needs to be enabled, you can write 0 using pin APIs and enable the device.
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
If you need the demux to inactive by default, use a pull up network. When the demux needs to be enabled, you can write 0 using pin APIs and enable the device.
Best Regards,
Vasanth