- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to break away all the modules on the prototyping kit, leaving just the PSoC Wi-Fi BT prototyping board.
I then want to reprogram the PSoC62, changing the pin functionalities for what I need.
I don't want to have to start this project from scratch though, as I would still like to keep the pin connections/programming for the BT module that is on board.
Is there an example code for this?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately, the device CY8C624ABZI-D44 is not supported in PSoC Creator any more. You need to get started with it using Modus Toolbox.
Modus Toolbox 2.0 (supporting development of CYW4343W) will be released in near future.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately, the device CY8C624ABZI-D44 is not supported in PSoC Creator any more. You need to get started with it using Modus Toolbox.
Modus Toolbox 2.0 (supporting development of CYW4343W) will be released in near future.