Sep 02, 2019
02:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 02, 2019
02:41 AM
Hello,
I am working on CYT4B controller. I need to configure UART driver for my project. I have an example driver(given by cypress).
I have few doubts :
- My driver is working fine on low level(directly writing and reading from FIFO register) but, it is not working with high level API where transmit and receive happens with help of interrupt. Basically i am not able to understand the ISR configuration.Cy_SysInt_SetSystemIrqVector(stc_sysint_irq_cfg_uart.sysIntSrc, Scb_UART_IntrISR);
- While going through the code i understood that, in high level tx/rx is event based. So, does it need some os configuration?
Thanks in Advance
Solved! Go to Solution.
1 Solution
Sep 02, 2019
07:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 02, 2019
07:37 PM
Hello,
This topic is not suitable to be discussed here in this community. Please kindly get in touch with your Cypress contact window for help.
Best regards,
Amy
2 Replies
Sep 02, 2019
07:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 02, 2019
07:37 PM
Hello,
This topic is not suitable to be discussed here in this community. Please kindly get in touch with your Cypress contact window for help.
Best regards,
Amy
Sep 02, 2019
11:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 02, 2019
11:55 PM
Because old project development needs to be continued.