- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
PSOC4000L datasheets says IMO clock accuracy to be ±2 percent accuracy across all frequencies with trim. The IMO trimming procedure is done on startup loading SFLASH trimmed values stored by custumer during production process. May these values differ from sample to sample or they are the same? Why an accuracy of only 2% is obtained? Could be possible to load different values to obtain a better accuracy of 2% (also without using WCO or USB lock functionality)?
Thank you
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To reduce clock error you need to measure against a known precise clock which is done in the trimming process at the factory. Over the temperature range this value is exact to 2%. When a more precise clock is needed you are required to use a crystal as reference.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To reduce clock error you need to measure against a known precise clock which is done in the trimming process at the factory. Over the temperature range this value is exact to 2%. When a more precise clock is needed you are required to use a crystal as reference.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So you mean the factory trimming process is made by Cypress is made chip by chip and it is already made with the better accuracy is possible?
Roberto Casella
Electronic R&D Department
Da: "JoMe_264151" <community-manager@cypress.com>
A: "Roberto Casella" <roberto.casella@ave.it>
Inviato: Venerdì, 30 agosto 2019 11:35:13
Oggetto: Re: - IMO clock accuracy
[ http://www.cypress.com/ |
]
[ https://community.cypress.com/?et=watches.email.thread |
Cypress Developer Community
]
IMO clock accuracy
reply from https://community.cypress.com/people/JoMe_264151?et=watches.email.thread in PSoC 4 MCU Community - https://community.cypress.com/message/207710?et=watches.email.thread#207710
To reduce clock error you need to measure against a known precise clock which is done in the trimming process at the factory. Over the temperature range this value is exact to 2%. When a more precise clock is needed you are required to use a crystal as reference.
Bob
Reply to this message by replying to this email, or https://community.cypress.com/message/207710?et=watches.email.thread#207710
Start a new discussion in PSoC 4 MCU Community by mailto:discussions-community-MCU-psoc--4@broadcomwiced-v8.hosted.jivesoftware.com or at https://community.cypress.com/choose-container.jspa?contentType=1&containerType=14&container=2172&e...
Following https://community.cypress.com/message/207710?et=watches.email.thread#207710 in these streams: Inbox
This email was sent by Cypress Developer Community because you are a registered user.
You may https://community.cypress.com/unsubscribe.jspa?email=roberto.casella%40ave.it&token=9e9d83bd9e0c817... instantly from Cypress Developer Community, or adjust email frequency in your https://community.cypress.com/user-preferences!input.jspa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
YES, PSoC has trimming value for IMO. Please refer following document.
PSoC 4200L Family PSoC 4 Architecture TRM, Document No. 001-97952
In addition, if PSoC 4200L is connected to a USB host, the IMO is calibrated with the SOF signal on the USB bus.