Aug 25, 2019
11:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 25, 2019
11:34 PM
Hello i have 2 LDO with output of 3.3V for each CCG3PA should i use just one LDO for both ?
Their both on same PCB but work independently but communicate throughout I2C.
Solved! Go to Solution.
- Tags:
- ez-pd ccg3pa
1 Solution
Aug 26, 2019
01:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 26, 2019
01:09 AM
Hi ,
From design cost down, one LDO is enough for your design. Each CCG3PA active mode is about 10mA.
Best Regards,
Lisa
2 Replies
Aug 26, 2019
01:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 26, 2019
01:09 AM
Hi ,
From design cost down, one LDO is enough for your design. Each CCG3PA active mode is about 10mA.
Best Regards,
Lisa
Aug 26, 2019
09:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 26, 2019
09:02 AM
Thanks Lisa