- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm using PSOC4 - CY8C4245PVI with external clk of 10Mhz at P0.6. This is working fine.
But my UART (SCB) is not working. I've configure UART for 115200baudrate.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm using PSOC4 - CY8C4245PVI with external clk of 10Mhz at P0.6. This is working fine.
How to judge the system work fine?
But my UART (SCB) is not working. I've configure UART for 115200baudrate.
The same project, if you change HFCLK clock to IMO, does it work?
Could you share your test project here?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How to judge the system work fine?
Driving LED with timer, on/off time of LED is changed according to HFCLK (24Mhz to 10Mhz).
The same project, if you change HFCLK clock to IMO, does it work?
Yes!!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1: I use the external clock 4MHz to test the function, the UART can work well.
2: What's the accuracy of the 10MHz? How do you get the clock?
3: Does the voltage match with each other? (PSoC, 10Mhz generator)
4: Choose the right COM Port.
5: Hope it can be helpful for you~