- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi community
I was following the documentation of the CE215119 - BLE Battery Level with PSoC® 6 BLE and it show 3 kind of interrupts but when I open the project it just the typical Interrupt, isr. How can I get those two more interrupts?
Thanks you all
Regards,
David
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Please find the attached project developed for CY8CKIT-062. The project contains BLE component configured with Battery level service.
Also it has a Timer to process BLE interrupts on every 10ms interval. A battery level simulator Timer to change the battery level, a pin interrupt to send the battery level information on every button press. Please check it once.
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi David,
The code example uses only one interrupt i.e. BLESS interrupt. Are you mentioning about the following documentation? I am not able to find information about 3 interrupt sources. Kindly point me to the document you have gone through.
https://www.cypress.com/file/401071/download
If you want to add other interrupts to the existing project, you can refer Interrupt code examples CE220169, CE219521.
You can also look at MCWDT interrupts and dedicated code example interrupt from the PSoC Creator code examples section.
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ganesh,
if you go to the page 3 under the section Switching the CPU Cores Usage, you can find the following statement:
"The BLE Subsystem (BLESS) interrupt must be assigned to the core where the controller runs. All additional interrupts (SW2, MCWDT, etc.) used in the example must be assigned to the host core".
Also in the Figure 3 from the documente the third figure shows 3 interrupts in the DWR section.
When I downloaded the example file, in the Interrupts section was only the BLE_bless_irs. How can I add the others two?
Regards,
David
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi David,
I got it. Thank you for pointing this out to us. Please give me one day to get back to you with corrections.
Thanks and regards
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Please find the attached project developed for CY8CKIT-062. The project contains BLE component configured with Battery level service.
Also it has a Timer to process BLE interrupts on every 10ms interval. A battery level simulator Timer to change the battery level, a pin interrupt to send the battery level information on every button press. Please check it once.
Thanks
Ganesh