- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sir,
I was testing wl cmd,there were some error,please help to check,my cmd as below:
wl mpc 0
wl up
wl band b
wl channel 1
wl curpower
Error: read ppr board limit failed
Chip number:cyw43438
OS: Android 7.1
CPU: Allwinner
The attached are Doc and my actually test .
Thanks,
Leo
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Raktim,
It works fine in this case,thanks!
But in another case ,I use my own WL,this error can also happen ,then I switch your WL_tool ,but still can't work,can you help me to release wl_tool again,thanks~
Project info:
Chip number:cyw43438
OS:Android 5.1
CPU:Ingenic
Framework:MIPS(X64)
Best Regards,
Leo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Raktim,
My platform is Ingenic M200.I used your wl tool to test,it din not work with below error:
Thanks,
Leo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Could you please provide the output of uname -a?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Raktim,
My kernel has no uname cmd,my linux version as below:
Thanks,
Leo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Based on your suggestion, I had compiled the wl tool for mips(x64) architecture which is evident from the error log you have posted sequentially. I am thinking the architecture that you have mentioned is not the correct one. Can you please use the attached wl tool and try (I have compiled this one based on my understanding)?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Raktim,
The wl tool that you release can run up,but wl curpower can still turn error as below:
Thanks,
Leo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the clm_blob and nvram file you are using? (Can you attach them for us to check?)
Will it be okay for you to fork-off this discussion to a new thread since the initial and subsequent queries regarding non-functional wl tool is already resolved?