- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear,
I made a dock and used the CYPD4236-40LQXI_dock sample code.
Stopped in step 8 when entering DisplayPort Alternate Mode.
I can't see the "DP_Status_update" sent from my laptop.
How to solve this error?
This is PASS case.
This is fail case.
https://community.cypress.com/message/204704#204704
MaLi_3529141 2019/8/2 上午 2:35
Dear,
I made a dock and used the CYPD4236-40LQXI_dock sample code.
Stopped in step 9 when entering DisplayPort Alternate Mode
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Could you please kindly let me know why your SOURCE is always send below package after Discover Mode was completed. Could you please clear this on source side?
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Lisa,
But this source side is a laptop, and I can't control it.
Is there any way to avoid it sending this message?
Best Regards,
Manu
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Manu,
Could you please kindly use a laptop which was mass production on the market? And test it again?
Best Regards,
Lisa