- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
While flashing .hex file using SEGGER JFlash, I am getting an error. Below is the error description-
I am getting "Timeout while erasing sectors, RAMCode did not respond in time", while erasing or flashing and blank checking.
and also what is blank checking?
----------------------------------------------------------------
- Start of erasing sectors
- Blank checking 0x10000000 - 0x1001FFFF
- ERROR: Timeout while blank checking, RAMCode did not respond in time. (PC = 0x7BEB7BFB, CPSR = 0x967BFC7D, LR = 0x01000003)!
- ERROR: Failed to blank checking.
Failed to execute RAMCode for blank check!
- ERROR: Error while blank checking.
- Erasing range 0x10000000 - 0x1001FFFF ( 4 Sectors, 128 KB)
- ERROR: Timeout while erasing sectors, RAMCode did not respond in time. (PC = 0x7BEB7BFB, CPSR = 0x967BFC7D, LR = 0x81000003)!
- ERROR: Failed to erase sectors.
- End of erasing sectors
- ERROR: Erase failed
- Start of restoring
- End of restoring
- ERROR: Failed to auto program target
Disconnecting ...
- Disconnected
------------------------------------------------------------------------------------
Thannks
Sumit
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Kindly download latest JFlash from Segger website (currently v6.48a). JFlash V6.47e still didn't fully support our Traveo II MCU.
SEGGER - The Embedded Experts - Downloads - J-Link / J-Trace
Best regards,
Amy Wang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The device ID of CYT2B9 and CYT2B7 is different and need to be selected correctly.
--Amy Wang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
But now, it is not flashing using corrected id.
could you tell me what could have gone wrong?
please suggest.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have attached the issue that I am facing in reply to the post.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Kindly download latest JFlash from Segger website (currently v6.48a). JFlash V6.47e still didn't fully support our Traveo II MCU.
SEGGER - The Embedded Experts - Downloads - J-Link / J-Trace
Best regards,
Amy Wang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Amy
I tried that, but it showing the same issue with latest Jflash.
Mistakenly I flashed CYT2B75CAE with CYT2B95CAE device selected once
Initially it was flashing fine.
Please suggest on this.
Regards
Sumit