Miniprog3 XRES influence the connect when programming mode is Power Cycle?

Announcements

Live Webinar: USB-C adoption. Simple & Cost-efficient solutions | April 18th @9am or 5pm CEST. Register now !

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
rttt_3611331
Level 3
Level 3
First like given

I used MiniProg3+PSoC Programming(3.28.4.4307) to connect my devices, Programming Mode is "Power Cycle". Protocol is "SWD", if I connected XRES of MiniProg3 to my devices, everthing is good, while I did't connect XRES Pin, PSoC Programming got error.

Is Pin XRES influencing the "Power Cycle" Mode?

LisaZ_26

0 Likes
1 Solution

Hi ,

Could you please kindly try to use same setting to programming other devices?

Could you please kindly use shorter length wires between MiniProg3 and CCG3 Device?

Best Regards,

Lisa

View solution in original post

0 Likes
6 Replies
ShifangZ_26
Moderator
Moderator
Moderator
10 likes given 250 sign-ins 1000 replies posted

Hi ,

May I know the device you was programmed? If you are programming CCG3PA, It shall not no error without AXRES wire to miniProg3.

Could you please screen shot the error in this threads?

Best Regards,

Lisa

0 Likes

thank you, my device is cypd 3135. connect XRES, read success, without will fail.

pastedImage_1.png

t

0 Likes

Glad to know you can read out. Could you please screen shot the error you said without XRES in this threads?

Best Regards,

Lisa

0 Likes

Without XRES. Other configs are the same the above pic.

pastedImage_0.pngLisaZ_26

0 Likes

Hello,

     Any response?  MiniProg3 did't support Power Cycle Mode? 

thx.

H

0 Likes

Hi ,

Could you please kindly try to use same setting to programming other devices?

Could you please kindly use shorter length wires between MiniProg3 and CCG3 Device?

Best Regards,

Lisa

0 Likes