- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I used MiniProg3+PSoC Programming(3.28.4.4307) to connect my devices, Programming Mode is "Power Cycle". Protocol is "SWD", if I connected XRES of MiniProg3 to my devices, everthing is good, while I did't connect XRES Pin, PSoC Programming got error.
Is Pin XRES influencing the "Power Cycle" Mode?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Could you please kindly try to use same setting to programming other devices?
Could you please kindly use shorter length wires between MiniProg3 and CCG3 Device?
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
May I know the device you was programmed? If you are programming CCG3PA, It shall not no error without AXRES wire to miniProg3.
Could you please screen shot the error in this threads?
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you, my device is cypd 3135. connect XRES, read success, without will fail.
t
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Glad to know you can read out. Could you please screen shot the error you said without XRES in this threads?
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Any response? MiniProg3 did't support Power Cycle Mode?
thx.
H
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Could you please kindly try to use same setting to programming other devices?
Could you please kindly use shorter length wires between MiniProg3 and CCG3 Device?
Best Regards,
Lisa