- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I try to use cy4531 to connect device by typec port, and got error.
0 HID devices found.
1 USB-Serial Bridge devices found.
Flashing device is UFP, initiating DR_SWAP
DR Swap Successful
PD contract established.
Error: VDM response read failed on PORT:0
Device Discovery completed.
Any reasons why this problem happened? thanks.
Solved! Go to Solution.
- Tags:
- ccg3
- cy4531
- ez-pd ccg3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
This Error usually will show up because the device connected did not enable the corresponding macro in the code which casue the VDM communication failed. I suggest you program the chip with the original hex file and try again.
Regards,Eddie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I guess you are trying to program the CCG3 device on CY4531. You should follow the operation guide in the CY4531 kit guide:
Ensure that the voltage selection jumper (J3) is set to 5 V (pins 2 and 3 of jumper J3 on the CCG3 daughter card are
shorted). Also, ensure that the I/O supply selection jumper (J4) is set to VDDD of the CCG3 device (pins 2 and 3 of
jumper J4 on the CCG3 daughter card are shorted).
Connect the USB Type-A to Mini-B cable from host PC to CCG3 daughter card
Regards,
Eddie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Config is correct. Any clues about that error? "Error: VDM response read failed on PORT:0"
thanks.
h
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
This Error usually will show up because the device connected did not enable the corresponding macro in the code which casue the VDM communication failed. I suggest you program the chip with the original hex file and try again.
Regards,Eddie