- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please answer below.
The same question is written in English and Japanese.
・English
Device Security is set to "PROTECTED mode".
I am thinking as follows. Are you sure?
"PROTECTED mode" does not run "Verify" of "PSoC Programmer".
・Japanese(日本語)
Device Securityを"PROTECTED mode"に設定しております。
以下の様に考えております。間違いないでしょうか?
"PROTECTED mode"では、PSoC ProgrammerのVerifyはできない。
Regards
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
During the verify operation, the PSoC Programmer reads the flash blocks from the target device and compares it with the hex file you have specified. Because the device security is in PROTECTED mode, the PSoC Programmer cannot read the flash. So, it will throw an error. You can try Verify Checksum operation which verifies the checksum of the target device with the hex file.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
During the verify operation, the PSoC Programmer reads the flash blocks from the target device and compares it with the hex file you have specified. Because the device security is in PROTECTED mode, the PSoC Programmer cannot read the flash. So, it will throw an error. You can try Verify Checksum operation which verifies the checksum of the target device with the hex file.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
SanjeevG_16 - san
Thank you for your support.
Regards,