- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I taught i had seen somewhere in the datasheet that the fine timer interval could be set as 1ms, but i can only seem to get 12ms at best?
I am trying to read a sensor running at 500hz(2ms)? I was trying to do it via the fine timer.
If i set up an interrupt, detecting the rise edge (new data when the interrupt rises), could the module handle been called every 2ms?
Regards,
Luke.
Solved! Go to Solution.
- Labels:
-
GPIO
-
I2C
-
ReadWrite Characteristics
-
SDK 2.X
-
Timers
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The highest resolution (soft) application timer is the 12.5 ms fine timer.
This thread and others talks about the problems that can be created when trying to set the timer any lower:Re: how to set a timer at 2ms
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The highest resolution (soft) application timer is the 12.5 ms fine timer.
This thread and others talks about the problems that can be created when trying to set the timer any lower:Re: how to set a timer at 2ms