- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am Using CY7C68013A for USB interface and transfer data from FPGA to PC of Bulkloop_VSC C#. at starting the device detecting (photo1) but after i Download the HEX file the device detaching but now it is showing as unknown device (photo3) as shown in figures. anyone has idea of solving the problem share with me. The Hex file is generated in Keil for slave FIFO operation. anyone find any mistake in slave.c file please inform me. the pins that i used are according to my selection.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Pavan,
I will send it through direct message. Please check.
Best Regards,
Yatheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Pavan,
Can you please share the entire project with us so that we can reproduce the issue on our side.
Best Regards,
Yatheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yes i will share the project with you please share the mail id .
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Pavan,
I will send it through direct message. Please check.
Best Regards,
Yatheesh