Jul 10, 2019
04:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 10, 2019
04:07 AM
Hello,
I'm working on a S6BT112A design without a MCU and can therefore not simply delay the rise of NSLP on Power-On.
Would it be a valid design to connect NSLP permanently to +5V?
Would this put the S6BT112A into Normal Mode after Power On?
+5V would be available sooner to the circuit than V_Bat, could this be an issue if the NSLP & SELMS Pins are driven high before the Bat Pin is powered?
Here is a quick illustration of my intended circuit.
Best Regards
Achim
Solved! Go to Solution.
Labels
1 Solution
Jul 19, 2019
01:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 19, 2019
01:53 AM
Hello
We think your intended circuit can work normally.
Thanks
Cypress) Kuninaka
2 Replies
Jul 18, 2019
12:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 18, 2019
12:35 AM
Hello
We are confirming it, please wait a moment.
Thanks
Kuninaka
Jul 19, 2019
01:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 19, 2019
01:53 AM
Hello
We think your intended circuit can work normally.
Thanks
Cypress) Kuninaka