- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please answer below.
The same question is written in English and Japanese.
・English
This connector is used by connecting the XRES terminal on the MinProg3 to the XRES terminal on the PSoC4100SP.
The XRES terminal on the PSoC 4100SP is for input only, but is the XRES terminal on the Miniprog3 for output only (Not bi-directional, no reset input)?
・Japanese
MinProg3のXRES端子とPSoC4100SPのXRES端子を接続し使用しております。
PSoC4100SPのXRES端子は入力専用端子ですが、
Miniprog3のXRES端子は出力専用端子(双方向ではない、リセット入力機能をもたない)でしょうか?
Regards
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The XRES terminal of MiniProg 3 is used to reset the device it connects to (PSoC 4100SP).
There is no reset available either in MiniProg 3 or MiniProg 4. In case you want a reset of MiniProg for some reason, you can do a power cycle.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
XRES pin on MiniProg3 is output. not bidirectional.
thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for your support