Jul 08, 2019
05:42 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 08, 2019
05:42 AM
I'm using a CYBLE-212023-10 module, with the "EZ-Serial BLE Firmware Platform", and I'd like to use directed advertising.
I can see how to enable directed advertising using command 4/8, "gap_start_adv", but how do I specify the address I'd like to advertise to?
Solved! Go to Solution.
Labels
- Labels:
-
BLE
1 Solution
Jul 11, 2019
10:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 11, 2019
10:55 PM
Hello,
Apologize for the delay. The current EZ-Serial FW does not support the directed advertising.
Thanks,
P Yugandhar.
1 Reply
Jul 11, 2019
10:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 11, 2019
10:55 PM
Hello,
Apologize for the delay. The current EZ-Serial FW does not support the directed advertising.
Thanks,
P Yugandhar.