- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When I power up the device, the touch keys are always triggered although my figure don't press the key.
The picture is as follow.
We can see from the picture, The baseline is always less than the raw count although I don't touch the button.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI JaZh_3086286
Can you please share your project as well? Please refer this link Archiving a PSoC Creator Design for details on archiving a PSoC creator project.
Are you using the Cypress kit or a custom layout?
You can enable sensor auto reset by double clicking the CapSense component-> advanced tab-> General-> Enable sensor auto reset.
Please note that if this is configured, the sensor will not register long presses.
Thanks and regards
Harigovind
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi JaZh_3086286
Can you please attach your project so that we can debug the issue at our end?
Could you also let us know which device you are using?
Thanks and regards
Harigovind
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I use the Cy8c4146AZI-s455.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI JaZh_3086286
Can you please share your project as well? Please refer this link Archiving a PSoC Creator Design for details on archiving a PSoC creator project.
Are you using the Cypress kit or a custom layout?
You can enable sensor auto reset by double clicking the CapSense component-> advanced tab-> General-> Enable sensor auto reset.
Please note that if this is configured, the sensor will not register long presses.
Thanks and regards
Harigovind