FAILED! PSoC device is not acquired! CYBLE-014008-00 programming

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
amca_4295051
Level 1
Level 1

Hi,

I want to program CYBLE-014008-00 by miniprog3 and CYBLE-014008-Prog. But get the failed information FAILED! PSoC device is not acquired!

How can I get it work? Thanks.

The connection is as the following picture.

cypress.jpg

cypress2.png

0 Likes
1 Solution
DheerajK_81
Moderator
Moderator
Moderator
First comment on KBA First comment on blog 5 questions asked

Since the board is not receiving power externally, please use the Miniprog3 to supply power. The PSoC Programmer log shows Power On, but I do not see the Target power led lit in the picture attached.

pp1.PNG

Ensure you have both the jumpers J3 and J5 on.

Please refer the Troubleshooting PSoC® 3/4/5LP Programming/Debugging Issues - KBA210619​ for more information.

Regards,

Dheeraj

View solution in original post

0 Likes
1 Reply
DheerajK_81
Moderator
Moderator
Moderator
First comment on KBA First comment on blog 5 questions asked

Since the board is not receiving power externally, please use the Miniprog3 to supply power. The PSoC Programmer log shows Power On, but I do not see the Target power led lit in the picture attached.

pp1.PNG

Ensure you have both the jumpers J3 and J5 on.

Please refer the Troubleshooting PSoC® 3/4/5LP Programming/Debugging Issues - KBA210619​ for more information.

Regards,

Dheeraj

0 Likes