- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I want to program CYBLE-014008-00 by miniprog3 and CYBLE-014008-Prog. But get the failed information FAILED! PSoC device is not acquired!
How can I get it work? Thanks.
The connection is as the following picture.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Since the board is not receiving power externally, please use the Miniprog3 to supply power. The PSoC Programmer log shows Power On, but I do not see the Target power led lit in the picture attached.
Ensure you have both the jumpers J3 and J5 on.
Please refer the Troubleshooting PSoC® 3/4/5LP Programming/Debugging Issues - KBA210619 for more information.
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Since the board is not receiving power externally, please use the Miniprog3 to supply power. The PSoC Programmer log shows Power On, but I do not see the Target power led lit in the picture attached.
Ensure you have both the jumpers J3 and J5 on.
Please refer the Troubleshooting PSoC® 3/4/5LP Programming/Debugging Issues - KBA210619 for more information.
Regards,
Dheeraj