FX2LP EP1IN problem

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
MoTa_938296
Level 1
Level 1

I assume that SIE of FX2LP responds immediately to EP1IN bulk transaction without NACK one or two times soon after "SET_FEATURE(to endpoint81) REQUEST" although firmware does not arm the EP1IN yet.

EP1IN is armed in accordance with timer2 expilation by polling TF2. SIE seems to ignore these intervals. Is my opinion right ?

0 Likes
1 Solution

Hello,

There may be my firmware issue (handling of timer2 function).So I would reserve judgment for the time being.

This issue will be fixed If I can cancel (disarm) previously (re)armed EP1IN.

Best Regards,

MoTa

View solution in original post

0 Likes
3 Replies
MoTa_938296
Level 1
Level 1

Please note that there was an error in the post where the "REQUEST"was incorrectly given as "SET_FEATURE", where it should have been "CLEAR_FEATURE".

0 Likes
Sananya_14
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hello,

Please clarify my understanding of your query- are you seeing data on the host after the Clear Feature request on the endpoint clears STALL condition? Is this happening even in the interval the endpoint is not armed?

Best Regards,

Sananya

0 Likes

Hello,

There may be my firmware issue (handling of timer2 function).So I would reserve judgment for the time being.

This issue will be fixed If I can cancel (disarm) previously (re)armed EP1IN.

Best Regards,

MoTa

0 Likes