- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am working on FPGA vetrtex-5 LX50 EVALUATION BOARD, Which has CY7C68012A device and i connected the usb cable to pc and device. but in USB control centre , FX2LP device is not showing in the list. I installed CYPRESS SUIT USB 3.4.7. What is the problem?? whether it is software or any mistake in connecting. I am using this for slave FIFO mode of operation... any little help makes my work easy... i am new to cypress.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Pavan,
Please check if FX2LP device is getting detected in device manager under Universal Serial Bus controllers or any other section when connected.
Best Regards
Yatheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Pavan,
Please check if FX2LP device is getting detected in device manager under Universal Serial Bus controllers or any other section when connected.
Best Regards
Yatheesh