- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using the S29GL-S nor flash, because the datasheet describle that WP pin has internal pull-up, when unconnected, WP is high level.
So I do not connect WP pin in my design circuit, but i measure WP in is low level , who can tell me why? I make sure that WP pin is not short with other pin.
- Labels:
-
Parallel NOR
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The WP# can be connected to VDD or left open in the design. The WP is not driven by the flash so the flash is not setting it to low. Can you recheck again for any short-circuit or wrong connections on the pin. Is it possible for you to pull up the pin or tie it to VCC and then check its voltage level.
then
The pin should be internally pulled up to VDD if left floating. If you find no errors at your end then we need to check on the device.
Also can you let us know as to how many devices are showing this behavior.
Thanks and Regards,
Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have three same board with the S29GL-S nor flash, all WP pin of the chip on three board is 0.4V. When I pull-up WP pin on the external, it is 3.3V, and high level. I have check WP pin ,and make sure that WP pin is not short to other pin, VCC and gound. I dont kown why ?