- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
wiced_init() times out with the following signature:
WPRINt_WWD_ERROR(("Timeout while waiting for high throughtput clock\n"));
This is a new target board and the platform files have been copied and modified for my target. I have attached them.
Where do I start looking to fix this?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
the problem is gone - the 1DX was booting from an external Serial Flash that was not there - so I moved the 1DX image inside
the MCU flash by setting the RESOURCES_LOCATION ?= RESOURCES_IN_DIRECT_RESOURCES in the platform makefile.
And our board uses 1.8V for all components - and 1DX did not complain !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
the problem is gone - the 1DX was booting from an external Serial Flash that was not there - so I moved the 1DX image inside
the MCU flash by setting the RESOURCES_LOCATION ?= RESOURCES_IN_DIRECT_RESOURCES in the platform makefile.
And our board uses 1.8V for all components - and 1DX did not complain !