- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please answer below.
The same question is written in English and Japanese.
・English
https://community.cypress.com/message/199089
Continues the above thread.
The waveform appears to be a signal that switches faster than 1 MHz.
Is it OK to set Slew rate to Slow?
・Japanese
https://community.cypress.com/message/199089
上記スレッドの続きになります。
頂いた波形は1MHzより早く切り替わる信号に見えます。
Slew rateをSlowに設定して問題ないのでしょうか?
Regards
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
Yes, it is OK to set the Slew rate to slow, if the rise and fall time of the waveform after setting the slew rate to slow meets your specifications.
Best Regards
Ekta
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
Yes, it is OK to set the Slew rate to slow, if the rise and fall time of the waveform after setting the slew rate to slow meets your specifications.
Best Regards
Ekta
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ekta-san
Thank you for your answer.
Regards