- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The PDM component sinc rate can be set from 0 to 127. Does the actual hardware use the raw value or does it add 1 to it?
If raw value, 0 seems like an invalid configuration, but the component configuration dialog allows it. That also means that the very handy power-of-two value of 128 is not available.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Eugene,
Apologies for the delay. The sinc rate of the component can take values from 1-127. It takes the raw value, and it do not add 1 to it. So the value 128 is not available in the component. We will take necessary steps to remove 0 from the permissible values.
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When Cypress eliminated real support and moved everything to the forum, I was under the impression that Cypress employees would be responding to posts on here. Is that not actually the case and there's no support left at all?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Eugene,
Apologies for the delay. The sinc rate of the component can take values from 1-127. It takes the raw value, and it do not add 1 to it. So the value 128 is not available in the component. We will take necessary steps to remove 0 from the permissible values.
Best Regards,
Vasanth