- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI Cypress:
when we use miniprog2 in the project, i find that we can donwload the hex but can't use in the Capsense Tuner, it show below:
1、it can download the hex;
2、it can't use in capsense tuner ;
3、it can't use in program:
4、system can' t use it,
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi David,
Looks like the debugger is in CMSIS-DAP mode, not KitProg mode.
Are there any switch on your debugger called "SW3" something else like that?
You can try to press the switch for ~5 seconds and then release it to check if it goes to KitProg mode?
If it doesn't work, try enter the debugger into its bootloader mode(Entered Bootloader mode by holding the Reset button during kit power-up) and bootload its driver again, with using PSoC Programmer(connect to the kit, go to the Utilities tab, and press the Upgrade Firmware button).
Thanks,
Ryan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi David,
Looks like the debugger is in CMSIS-DAP mode, not KitProg mode.
Are there any switch on your debugger called "SW3" something else like that?
You can try to press the switch for ~5 seconds and then release it to check if it goes to KitProg mode?
If it doesn't work, try enter the debugger into its bootloader mode(Entered Bootloader mode by holding the Reset button during kit power-up) and bootload its driver again, with using PSoC Programmer(connect to the kit, go to the Utilities tab, and press the Upgrade Firmware button).
Thanks,
Ryan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi Ray:
ok, i wil try it again, tks;