USB3.0 HUB CYUSB3302-68LTXI support

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
dawoc_3906551
Level 1
Level 1
First like given

We are using one new USB3.0 HUB CYUSB3302-68LTXI.

Do you have any idea for the MODE SEL ?

  1. What is the default setting?
  2. What would happen when I pull up SEL0&1 when power on.
  3. Do I need to pre-program the EEPROM before I use it?
0 Likes
1 Solution
Sananya_14
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hello,

Please refer to Page 24 in the datasheet for MODE_SEL settings.

1. Default setting is 11 which corresponds to internal ROM mode.

2. Pulling both up would cause the hub to boot from the internal ROM firmware which cannot be modified.

3. No, HX3 itself can be used to program the EEPROM before setting MODE_SEL pins to the I2C boot mode. The programming through HX3 is done using Blaster Plus utility. Please refer to the KBA for more details on the process.

Best Regards,
Sananya

View solution in original post

1 Reply
Sananya_14
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hello,

Please refer to Page 24 in the datasheet for MODE_SEL settings.

1. Default setting is 11 which corresponds to internal ROM mode.

2. Pulling both up would cause the hub to boot from the internal ROM firmware which cannot be modified.

3. No, HX3 itself can be used to program the EEPROM before setting MODE_SEL pins to the I2C boot mode. The programming through HX3 is done using Blaster Plus utility. Please refer to the KBA for more details on the process.

Best Regards,
Sananya