Cy8CKIT can not be programmed

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
AlTe_4253701
Level 2
Level 2

Why I can not write to Tech support.

I purchased a CY8CKIT PSoc Creator 4.2 say the device was recognized but I can program , The kit is new why ?

pastedImage_0.png

0 Likes
1 Solution

I suggest that you use PSoC Programmer 3.28.x and update the kitprog (Debugger hardware on kit) to the latest version.

In PSoC Programmer, select the "Utilities" Tab and select "Upgrade Firmware" while your kit is attached.  Give it about a minutes and it should update the kitprog.  Even though your kit is new, Cypress updates the firmware and software a couple times a year.

Mark

View solution in original post

0 Likes
3 Replies
MotooTanaka
Level 9
Level 9
Distributor - Marubun (Japan)
First comment on blog Beta tester First comment on KBA

Hi,

It seems that your board is bootloader mode. (May be, I'm wrong though)

Please try

(1) Hold reset sw for a few second then try debug from your PSoC Creator again.

(2) If (1) does not work, use PSoC Programmer and update firmware of your kit.

moto

0 Likes

I suggest that you use PSoC Programmer 3.28.x and update the kitprog (Debugger hardware on kit) to the latest version.

In PSoC Programmer, select the "Utilities" Tab and select "Upgrade Firmware" while your kit is attached.  Give it about a minutes and it should update the kitprog.  Even though your kit is new, Cypress updates the firmware and software a couple times a year.

Mark

0 Likes

Thank you Mark , the problem was solved

Alberto

On Thu, May 30, 2019 at 3:28 PM MarkH_61 <community-manager@cypress.com>

0 Likes