- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am drawing my shematics, and I ask my self how to make a good connexion between my Host and two or more CY8CMBR3116.
For what I know, reading the datasheet, is I have a pull up resistor for the Hi pin.
I understand, the Xres pin is an active low external reset. In order to give to each 3116 IC is own I2C address, I want reset all the other IC. I was thinking connect each 3116 's Xres pin to differents digital pin of the Host, with a pull up resistor, I am correct ?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
MBR3116 XRES pin has an internal 40K ohm pull-up resistor, but i think you are correct, use one external pull-up resistor (like 4.7K + 104 cap) is recommended circuit if you want to control XRES pin use host IO.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
MBR3116 XRES pin has an internal 40K ohm pull-up resistor, but i think you are correct, use one external pull-up resistor (like 4.7K + 104 cap) is recommended circuit if you want to control XRES pin use host IO.